Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR › from 2021.02
RM33C0E _59 Vehicle Exterior _065470 MIRROR (EXT) _0332579 OUTER REAR VIEW MIRROR A

MIRROR (EXT)  OUTER REAR VIEW MIRROR  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 2.REMOVE OUTER MIRROR COVER WITH OUTER MIRROR HOLE COVER (w/o Panoramic View Monitor System)

Hide 87945 3.REMOVE OUTER MIRROR COVER (w/o Panoramic View Monitor System)

Hide 87945 4.REMOVE OUTER MIRROR COVER (w/ Panoramic View Monitor System)

Hide 5.REMOVE OUTER MIRROR HOLE COVER WITH SIDE TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)

Hide 86790F 6.REMOVE SIDE TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)

Hide 7.REMOVE NO. 2 OUTER MIRROR COVER

a.
B469071

Disengage the 2 claws and 2 guides to remove the No. 2 outer mirror cover.


Hide 87945C 8.REMOVE OUTER MIRROR LOWER COVER (w/ Panoramic View Monitor System)

a.
B606973

Disengage the 2 claws and 3 guides to remove the outer mirror lower cover.


Hide 81740 9.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY

Hide 87966 10.REMOVE OUTER MIRROR RETRACTOR (w/ Power Retract Mirror)

a.
B483087C01
2.615,1.802 2.927,1.958 0.313,0.156 10 false *a
*a Cut Here


Cut the wire harness sub-assembly at the position shown in the illustration.


b.
B485149C01
1.667,1.927 1.833,1.76 true 2.167,1.438 2.5,1.167 true 1.521,1.927 1.833,2.083 0.313,0.156 10 false *a 2.521,1 2.833,1.156 0.313,0.156 10 false *b
*a Clamp
*b Guide


Disengage the clamp.


c.

Remove the screw.


d.

Disengage the guide and remove the bracket.


e.
B485150

Disengage the 8 guides and remove the gasket sub-assembly.

NOTICE:

Make sure to replace the gasket sub-assembly with a new one.



f.
B483090

Disengage the 8 claws and guide to remove the lower cover.

NOTICE:

Make sure to replace the lower cover with a new one.



g.
B483091

Using a T25 "TORX" socket wrench, remove the 3 screws and base sub-assembly.

NOTICE:

Make sure to replace the screw with a new one.



h.
B483092

Remove the 3 screws.


i.
B483093

Disconnect the connector.


j.

Disengage the 2 clamps.


k.
B483094

Disconnect the connector to remove the actuator sub-assembly.


l.
B483095C01
0,0 0,0 false
V113147

Remove in this Direction


Pull the wire harness sub-assembly through the frame sub-assembly as shown in the illustration to remove the wire harness sub-assembly.

NOTICE:

Make sure to replace the wire harness sub-assembly with a new one.



m.
B483097

Remove the 2 screws.


n.
B483098

Remove the 2 screws and frame sub-assembly from the housing.

NOTICE:

Make sure to replace the frame sub-assembly with a new one.