This DTC is stored when the telematics transceiver detects an open or short in the manual (SOS) switch red indicator circuit of the manual (SOS) switch.
The manual (SOS) switch red indicator illuminates for 2 seconds and goes off when the ignition switch is turned to ON. If a malfunction in the safety connect system is detected, the manual (SOS) switch red indicator will illuminate.
If a malfunction in the telematics system is detected, the manual (SOS) switch red indicator will illuminate. However, the manual (SOS) switch red indicator may not illuminate when this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B157011 | Indicator (Red) Circuit Short to Ground | Manual (SOS) switch red indicator impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON | ·
Telematics transceiver ·
Roof console box sub-assembly (manual (SOS) switch) ·
Harness or connector |
| B157013 | Indicator (Red) Circuit Open | Manual (SOS) switch red indicator impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON | ·
Telematics transceiver ·
Roof console box sub-assembly (manual (SOS) switch) ·
Harness or connector |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for Toyota Connected Services)>PRECAUTION
When replacing the telematics transceiver, make sure to replace it with a new one.
If DTC B157011 or B157013 is stored, the manual (SOS) switch red indicator may not illuminate when another DTC is stored.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and wait for 10 seconds or more.
Turn the GTS on.
Check for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| w/ Sliding Roof | A |
| w/o Sliding Roof | B |
A
B
| *a | Component without harness connected
(Roof Console Box Sub-assembly (Manual (SOS) Switch)) |
Remove the roof console box sub-assembly (manual (SOS) switch).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL
Connect 2 dry-cell batteries (1.5 V each) in series.
Connect a positive (+) lead from the batteries to terminal 10 (IND1) and a negative (-) lead to terminal 16 (GND3) of the roof console box sub-assembly (manual (SOS) switch) connector.
Check if the manual (SOS) switch red indicator illuminates.
Manual (SOS) switch red indicator illuminates.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K151 telematics transceiver connector.
Disconnect the V14 roof console box sub-assembly (manual (SOS) switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K151-4 (IND1) - V14-10 (IND1) | Always | Below 1 Ω |
| K151-4 (IND1) or V14-10 (IND1) - Body ground | Always | 10 kΩ or higher |
| K151-3 (SIG-) - V14-16 (GND3) | Always | Below 1 Ω |
| K151-3 (SIG-) or V14-16 (GND3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Roof Console Box Sub-assembly (Manual (SOS) Switch)) |
Remove the roof console box sub-assembly (manual (SOS) switch).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL
Connect 2 dry-cell batteries (1.5 V each) in series.
Connect a positive (+) lead from the batteries to terminal 7 (IND1) and a negative (-) lead to terminal 12 (GND3) of the roof console box sub-assembly (manual (SOS) switch) connector.
Check if the manual (SOS) switch red indicator illuminates.
Manual (SOS) switch red indicator illuminates.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K151 telematics transceiver connector.
Disconnect the V18 roof console box sub-assembly (manual (SOS) switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K151-4 (IND1) - V18-7 (IND1) | Always | Below 1 Ω |
| K151-4 (IND1) or V18-7 (IND1) - Body ground | Always | 10 kΩ or higher |
| K151-3 (SIG-) - V18-12 (GND3) | Always | Below 1 Ω |
| K151-3 (SIG-) or V18-12 (GND3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telematics transceiver with a new one.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT