89342
1.REMOVE REAR CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
w/o Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
89348R
2.REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
w/o Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
89342A
3.REMOVE REAR CENTER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
w/ Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
89342
4.REMOVE REAR CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
w/ Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
89348S
5.REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
w/ Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
89348R
6.REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
w/ Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
82182
7.REMOVE NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)
w/o Parking Support Brake System:
Disengage the 2 clamps to remove the No. 2 luggage room wire.
8.REMOVE ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)
w/o Parking Support Brake System:
Remove the 2 ultrasonic sensor clips.
82182
9.REMOVE NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)
w/ Parking Support Brake System:
Remove the No. 2 luggage room wire.
81920
10.REMOVE REFLEX REFLECTOR ASSEMBLY LH
Remove the screw.
Disengage the claw and guide to remove the reflex reflector assembly LH.
81910
11.REMOVE REFLEX REFLECTOR ASSEMBLY RH
Use the same procedure as for the LH side.
52169C
12.REMOVE LOWER REAR BUMPER COVER (for Type A)
Remove the 2 screws.
Remove the 2 clips.
Disengage the 12 claws to remove the lower rear bumper cover.
52724
13.REMOVE REAR BUMPER EXTENSION MOULDING LH (for Type B)
Disengage the 4 claws to remove the rear bumper extension moulding LH.
52723
14.REMOVE REAR BUMPER EXTENSION MOULDING RH (for Type B)
Use the same procedure as for the LH side.
52166B
15.REMOVE REAR BUMPER CORNER EXTENSION LH (for Type B)
Disengage the 4 claws and 4 guides to remove the rear bumper corner extension LH.
52165D
16.REMOVE REAR BUMPER CORNER EXTENSION RH (for Type B)
Use the same procedure as for the LH side.
52461F
17.REMOVE REAR BUMPER PAD
Remove the rear bumper pad.
Use the same procedure for the RH side and LH side.
64770
18.REMOVE SPARE WHEEL COVER ASSEMBLY
64779E
19.REMOVE SPARE WHEEL COVER TRAY
64725D
20.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64749E
21.REMOVE LUGGAGE COMPARTMENT DOOR STRIKER COVER
58387
22.REMOVE REAR FLOOR FINISH PLATE
64721
23.REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER RH
64722
24.REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER LH
52576
25.REMOVE REAR BUMPER SIDE RETAINER LH
Remove the screw.
|
Remove in this Direction |
Disengage the 3 clips as shown in the illustration.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the 2 claws as shown in the illustration.
Disengage the guide to remove the rear bumper side retainer LH.
52575
26.REMOVE REAR BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
81560
27.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
81550
28.REMOVE REAR COMBINATION LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
52563D
29.REMOVE REAR BUMPER UPPER RETAINER LH
Remove the screw and rear bumper upper retainer LH.
52562E
30.REMOVE REAR BUMPER UPPER RETAINER RH
Use the same procedure as for the LH side.
52592
31.REMOVE REAR BUMPER SIDE SEAL LH
Remove the 2 grommets.
Remove the 2 clips and rear bumper side seal LH.
52591
32.REMOVE REAR BUMPER SIDE SEAL RH
Remove the 2 grommets.
Remove the 3 clips and rear bumper side seal RH.
52615
33.REMOVE REAR BUMPER ENERGY ABSORBER (for Type A)
|
Remove in this Direction |
Disengage the 2 guides to remove the rear bumper energy absorber as shown in the illustration.
52171C
34.REMOVE REAR BUMPER REINFORCEMENT (for Type A)
Remove the 6 bolts and rear bumper reinforcement.
52171C
35.REMOVE REAR BUMPER REINFORCEMENT (for Type B)
Remove the 6 bolts and rear bumper reinforcement.