The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear door lock with motor assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
74038B
4.REMOVE REAR DOOR ARMREST COVER SUB-ASSEMBLY
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
74260
6.REMOVE REAR ARMREST ASSEMBLY
67604
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68174A
8.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
67844A
9.REMOVE REAR DOOR NO. 2 SERVICE HOLE COVER
67842E
10.REMOVE REAR DOOR SERVICE HOLE COVER
67848A
11.REMOVE REAR DOOR NO. 1 VENT SEAL
67858B
12.REMOVE REAR DOOR PANEL PROTECTOR
68152C
13.REMOVE REAR DOOR GLASS RUN
67872
14.DISCONNECT REAR DOOR WEATHERSTRIP
Disconnect the rear door weatherstrip until the screw of the rear door rear lower window frame sub-assembly is visible.
67408F
15.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY
68124B
16.REMOVE REAR DOOR QUARTER WINDOW GLASS
68104
17.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
69060A
18.REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY
| *a | Release Plate |
|
Remove in this Direction |
Using a T30 "TORX" socket wrench, remove the 3 screws.
Move the rear door lock with motor assembly downward to disconnect it from the release plate of the rear door outside handle frame sub-assembly, and remove the rear door lock with motor assembly.
When reusing the rear door lock with motor assembly:
Remove the door lock wiring harness seal from the rear door lock with motor assembly.
69038A
19.REMOVE REAR DOOR LOCK COVER SUB-ASSEMBLY
Using a screwdriver, disengage the 2 claws as shown in the illustration.
|
Remove in this Direction |
Disengage the 2 claws to remove the rear door lock cover sub-assembly as shown in the illustration.
69740D
20.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
|
Remove in this Direction |
Remove the rear door lock remote control cable assembly as shown in the illustration.
69780B
21.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
|
Remove in this Direction |
Remove the rear door inside locking cable assembly as shown in the illustration.