The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hybrid battery thermistor removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
After the power switch is turned off, the radio and display receiver assembly records various types ofmemory and settings. As a result, after turning the power switch off, make sure to wait at least 85seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
G9510
1.REMOVE HV BATTERY
G920NB
2.REMOVE UPPER HV BATTERY COVER SUB-ASSEMBLY
G92Z0
3.REMOVE HV BATTERY JUNCTION BLOCK ASSEMBLY
G920R
4.REMOVE NO. 2 HYBRID BATTERY SHIELD SUB-ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Remove the 5 nuts.
| *1 | Rear No. 1 HV Battery Shield |
| *2 | No. 2 Hybrid Battery Shield Sub-assembly |
|
Pull Back |
Pull back the rear No. 1 HV battery shield and remove the No. 2 hybrid battery shield sub-assembly from the HV battery.
Pull back the rear No. 1 HV battery shield until it is separated from the stud bolt of the No. 2 hybrid battery shield sub-assembly.
G92E1A
5.REMOVE NO. 1 HV BATTERY INTAKE DUCT LH
Be sure to wear insulated gloves and protective goggles.
Remove the clip to disconnect the No. 1 HV battery intake duct LH from the HV battery.
Disengage the claw of hybrid battery thermistor (sensor portion) and remove the No. 1 HV battery intake duct LH.
G9282
6.REMOVE HYBRID BATTERY THERMISTOR
Be sure to wear insulated gloves and protective goggles.
Disengage the clamp.
Disengage the 2 claws and remove the No. 1 hybrid battery packing from the HV battery.
Disengage the clamp.
Disconnect the battery voltage sensor connector.
Disengage the 4 clamps.
Disengage the 3 claws of the hybrid battery thermistor (sensor portions) and remove the hybrid battery thermistor from the HV battery.