In this circuit, the combination meter assembly detects ODO/TRIP switch (trip switch) signals via a direct line.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ODO/TRIP Change Switch | ODO/TRIP switch (Trip switch) | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| Tester Display |
|---|
| ODO/TRIP Change Switch |
ODO/TRIP switch (trip switch) condition displayed on the GTS changes with the actual switch operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the trip switch.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>TRIP SWITCH>REMOVAL
Inspect the trip switch.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>TRIP SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K20 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K111-3 (A/B) - K20-1 (ODO) | Always | Below 1 Ω |
| K111-1 (E) - K20-5 (SW3) | Always | Below 1 Ω |
| K111-3 (A/B) or K20-1 (ODO) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K166-2 (A/B) - K20-1 (ODO) | Always | Below 1 Ω |
| K166-5 (E) - K20-5 (SW3) | Always | Below 1 Ω |
| K166-2 (A/B) or K20-1 (ODO) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG