Home › Engine / Hybrid System › 1BZ-FPE (ENGINE CONTROL) › DISTRIBUTOR › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073136 1BZ-FPE ENGINE CONTROL _0355843 DISTRIBUTOR A

1BZ-FPE ENGINE CONTROL  DISTRIBUTOR  INSTALLATION  


PROCEDURE

Hide 1.SET NO. 1 CYLINDER TO TDC/ COMPRESSION

Hide 17810A 2.INSTALL AIR FILTER

a.

Install the air filter to the cylinder head cover with the 2 bolts.


b.

Connect the vacuum hose to the air filter.


Hide 19207B 3.INSTALL DISTRIBUTOR HOUSING

a.

Install a new O-ring to the distributor housing.


b.

Apply a light coat of engine oil on the O-ring.


c.
A423943

Align the matchmark of the A part (the part one tooth is in defect) of distributor housing gear with that of distributor housing, then install the distributor housing with the 2 nuts.

Torque:

18.5 N*m (189 kgf*cm, 14 ft*lbf)



Hide 19100 4.INSTALL DISTRIBUTOR

a.

Install a new dust-proof packing to the distributor.


b.

Apply a light coat of engine oil on the dust-proof packing.


c.
A423944

Align the 3 grooves of the coupling, distributor case and distributor housing case.


d.

Install the distributor to the distributor housing.


e.
A423945

Install the rotor to the distributor.


f.

Turn the distributor, and align the signal rotor tooth with the signal generator projection, and tighten the bolt in that position.

Torque:

18.5 N*m (189 kgf*cm, 14 ft*lbf)



g.

Remove the rotor.


Hide 19121 5.INSTALL DUST PROOF COVER AND ROTOR

Hide 19101 6.INSTALL PACKING AND DISTRIBUTOR CAP

Hide 7.CONNECT VACUUM HOSES TO DISTRIBUTOR

Hide 8.CONNECT DISTRIBUTOR CONNECTOR

Hide 9.CONNECT HIGH-TENSION CORDS TO DISTRIBUTOR CAP