Home › Engine / Hybrid System › N04C-UH (ENGINE CONTROL) › ECD SYSTEM
RM2850E _51 Engine / Hybrid System _073137 N04C-UH ENGINE CONTROL _0355844 ECD SYSTEM C

N04C-UH ENGINE CONTROL  ECD SYSTEM  P0106  Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem  


DESCRIPTION

Refer to DTC P0105 (Click hereEngine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>P0105).

DTC No. DTC Detection Condition Trouble Area
P0106 Voltage output of the manifold absolute pressure sensor is out of the standard range
(2 trip detection logic)
Manifold absolute pressure sensor

CAUTION / NOTICE / HINT

HINT:
·

If DTCs P0105, P0107, and P0108 are output simultaneously, the manifold absolute pressure sensor circuit may be open or shorted. Perform troubleshooting for those DTCs first.

·

Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.



PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0106)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.


e.

Read the DTCs.


Result:
Result Proceed to
P0106 A
P0106 and other DTCs B



A

REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR

B