Home › Engine / Hybrid System › N04C-VQ (ENGINE CONTROL) › ECD SYSTEM
RM2850E _51 Engine / Hybrid System _073138 N04C-VQ ENGINE CONTROL _0355854 ECD SYSTEM D

N04C-VQ ENGINE CONTROL  ECD SYSTEM  DTC CHECK / CLEAR  


NOTICE:

When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.


HINT:
·

DTCs which are stored in the ECM can be displayed on the intelligent GTS. The intelligent GTS can display the current and pending DTCs.

·

Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.



CHECK DTC


a.

Connect the intelligent GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Check and make a note of the DTCs and freeze frame data.




CLEAR DTC


a.

Connect the intelligent GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Clear.


e.

Erase the DTCs and freeze frame data by pressing YES on the GTS.

NOTICE:

When DTC P0095, P0096, P0097, P0098, P0101, P0102, P0103, P0106, P0107, P0108, P0400, P1458, P1459, U1122 or U1123 is detected, the DTC cannot be cleared using the intelligent GTS.




CLEAR DTC (not using the intelligent GTS)


a.

Remove the EFI-MAIN fuse from the fuse block for more than 60 seconds, or disconnect the negative battery cable for more than 60 seconds.