N04C-VQ (ENGINE CONTROL)
ECD SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- HOW TO PROCEED WITH TROUBLESHOOTING
- CHECK FOR INTERMITTENT PROBLEMS
- BASIC INSPECTION
- REGISTRATION
- INITIALIZATION
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECM
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FREEZE FRAME DATA
- CHECK MODE PROCEDURE
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- P0045 The ignition switch is on (IG), battery voltage is 11 to 14 V, engine stopped or 5 seconds or more elapse...
- P0069 After the ignition switch is turned to ON or turned from ON to off, the difference between the atmospheric...
- P0087, P0190, P0191, P0192, P01932017.01–2019.08from 2019.08
- P0088, P0627, P12292017.01–2019.08from 2019.08
- P0093 DTC is output when following conditions (a), (b) and (c) are all met and if difference of common rail...2017.01–2019.08from 2019.08
- P0095, P0097, P0098
- P0096 When the following conditions (a) and (b) are met:(2 trip detection logic) (a) Vehicle is driven at varying...
- P0101 Air flow rate from mass air flow meter sub-assembly is out of specified threshold under the following...
- P0102, P0103
- P0106 Voltage output of the manifold absolute pressure sensor is out of the standard range (2 trip detection logic)
- P0107, P0108
- P0112, P0113
- P0115, P0117, P0118
- P0116 If the engine coolant temperature was between -40°C (-40°F) and 60°C (140°F) at engine start, and conditions...
- P0122, P0123
- P0168, P0180, P0182, P0183
- P0201, P0202, P0203, P0204, P062D
- P0217 The engine coolant temperature is 115°C (239°F) or higher for 30 seconds or more while the engine is running...
- P0219 The engine speed is 3740 rpm or more for 0.5 seconds or more when the vehicle is being driven at a speed of 3...
- P0234, P0299, P1251
- P0263, P0266, P0269, P0272
- P0335, P0339
- P0340 STA ON (2 trip detection logic): No camshaft position sensor signal to ECM while cranking for 4 seconds or...
- P0400 EGR air flow rate less than the specified value when following conditions (a), (b), (c), (d), (e) and (f) are...
- P0488 Condition (a) or (b) continues for more than 1 second (a) Throttle motor's activation duty is out of the...
- P0500 3 seconds or more has elapsed after STA signal is switched from on to off, conditions (a), (b), (c) and (d)...
- P0504 Conditions (a) and (b) continue for 0.5 seconds or more (1 trip detection logic): (a) Ignition switch ON (b)...
- P0560 Condition (a) or (b) continues (1 trip detection logic): (a) Significant decrease in battery voltage (b) Open...
- P0606, P060A, P060B
- P0617 When conditions (a), (b) and (c) are met, positive (+B) battery voltage of 10.5 V or more is applied to ECM...
- P062F Either condition below is met (1 trip detection logic): · Injector compensation code is not registered. ·...
- P0630 Either condition is met (1 trip detection logic): · VIN not stored in ECM · Input VIN in ECM not accurate
- P0704 No clutch switch signals to ECM despite vehicle driving with varying vehicle speed between 0 and 80 km/h. (1...
- P0724 Stop light switch remains on even when vehicle is driven in GO (30 km/h (19 mph) or more) and STOP (less than...
- P0850 No exhaust brake neutral switch signals to ECM despite vehicle driving with varying vehicle speed between 0...
- P1266 The pressure limiter valve remains open for 18 seconds or more due to the suction control valve being stuck...
- P1458, P1459
- P1530 Both of the following conditions (1) and (2) are met (1 trip detection logic): (1) Engine speed 10 km/h (6.3...
- P1603 2 seconds or more elapse after starting the engine, and the engine running, the engine stops for 0.5 seconds...
- P1604 Both conditions are met for 2 seconds or more*1 (1 trip detection logic): · STA signal is input to the ECM. ·...
- P1605 When the accelerator pedal is fully closed and the engine is idling, the speed of a specific cylinder is low...
- P1608 With the accelerator pedal fully depressed, engine output decreases for approximately 4 to 10 seconds due to...
- P1674 Open or short in exhaust brake solenoid circuit for more than 3 seconds with clutch pedal released (1 trip...
- P2120, P2121, P2122, P2123, P2125, P2127, P2128, P2138
- P2226, P2228, P2229
- U1122 Both of the following conditions are met: (a) Ignition switch ON (b) No communication between ECM and EGR...
- U1123 Both of the following conditions are met: (a) Ignition switch ON (b) No communication between ECM and...
- Engine Difficult to Start or Stalling2017.01–2019.08from 2019.08
- Black Smoke Emitted2017.01–2019.08from 2019.08
- Rough Idling or Excessive Engine Vibrations
- Engine Knocking or Rattling
- Lack of Power or Hesitation
- Fuel Injection System2017.01–2019.08from 2019.08
- ECM Power Source Circuit
- EDU Power Source Circuit
- VC Output Circuit2017.01–2019.08from 2019.08
- Starter Signal Circuit
- Brake Override System
- MIL Circuit
DIESEL THROTTLE BODY
ECM
ACCELERATOR PEDAL
MASS AIR FLOW METER
CAMSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR
ENGINE COOLANT TEMPERATURE SENSOR
INTAKE AIR TEMPERATURE SENSOR
MANIFOLD ABSOLUTE PRESSURE SENSOR
RELAY