A thermistor is built into the engine coolant temperature sensor and it changes its resistance value according to the engine coolant temperature.
The structure of the sensor and connection to the ECM is the same as the intake air temperature sensor.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0116 | If the engine coolant temperature was between -40°C (-40°F) and 60°C (140°F) at engine start, and conditions (a) and (b) are met:
(2 trip detection logic) (a) Vehicle is driven at varying speeds (accelerating and decelerating) (b) Engine coolant temperature remains within 3°C (5.4°F) of the engine starting temperature |
·
Engine coolant temperature sensor ·
Thermostat |
| If the engine coolant temperature was more than 60°C (140°F) at engine start, and conditions (a) and (b) are met:
(6 trip detection logic) (a) Vehicle is driven at varying speeds (accelerating and decelerating) (b) Engine coolant temperature remains within 1°C (1.8°F) of the engine starting temperature. |
If DTCs P0115, P0116, P0117, and P0118 are output simultaneously, the engine coolant temperature sensor circuit may be open or shorted. Perform troubleshooting for those DTCs first.
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P0116 is output | A |
| DTC P0116 and other DTCs are output | B |
A
B
Inspect the thermostat (Click hereEngine / Hybrid System>N04C-VQ (COOLING)>THERMOSTAT>INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG