While the ignition switch is off, battery voltage is supplied to terminal BATT of the ECM for storing DTCs and fuel injection feedback learning values.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0560 | Condition (a) or (b) continues (1 trip detection logic):
(a) Significant decrease in battery voltage (b) Open in back-up power source circuit |
·
Open in back-up power source circuit ·
Low battery voltage ·
ECM |
If DTC P0560 appears, the ECM does not store other DTCs.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
After turning ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A57-23 (BATT) - Body ground | Always | 11 to 14 V |
| *a | Rear view of wire harness connector
(to ECM) |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereEngine / Hybrid System>N04C-VQ (ENGINE CONTROL)>ECD SYSTEM>CHECK FOR INTERMITTENT PROBLEMS
NG
Disconnect the cable from the negative (-) battery terminal.
Disconnect the cable from the positive (+) battery terminal.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A57-23 (BATT) - Positive (+) battery terminal | Always | Below 1 Ω |
| A57-23 (BATT) or Positive (+) battery terminal - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the battery is not depleted.
Battery is not depleted.
| Proceed to |
|---|
| OK |
| NG |
OK
NG