26100
1.INSPECT DIESEL THROTTLE BODY
Check the throttle control motor operation.
Remove the air hose from the diesel throttle body.
Disconnect the throttle control motor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| h1-2 (VCR) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Throttle Control Motor) |
Connect the throttle control motor connector.
Turn the ignition switch to ON.
When the ignition switch is turned to off, make sure that the valve of the diesel throttle body operates.
The valve of the diesel throttle body operates.
Install the air hose to the diesel throttle body.
Check the throttle position sensor.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Warm up the engine.
The water temperature is 60 °(140°F) or more.
The fuel temperature is 20 °(68°F) or more.
Inspect the engine idling speed.
| Condition | Engine Idle Speed |
|---|---|
| A/C switched off | 600 to 700 rpm |
The shift lever should be in the neutral position and A/C switch should be turned off.
Enter the following menus: Power train / Engine and ECT / Data List / Actual Throttle Position.
Check that the value of diesel throttle angle is within the specification.
| Engine Condition | Throttle valve opening position expressed as percentage |
|---|---|
|
If the results are not as specified, check the diesel throttle body, wire harness and ECM. |
|
| During idling | 80 to 90 % |
| 1500 rpm | 0 to 70 % |