Home › Engine / Hybrid System › N04C-VQ (ENGINE CONTROL) › ACCELERATOR PEDAL
RM2850E _51 Engine / Hybrid System _073138 N04C-VQ ENGINE CONTROL _0355857 ACCELERATOR PEDAL G

N04C-VQ ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78100 1.INSPECT ACCELERATOR PEDAL ASSEMBLY

a.

Connect an intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the tester on.


c.

Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.


d.

While the accelerator pedal is depressed and released, check that the values of Accel Sensor Out No. 1 and Accel Sensor Out No. 2 are within the specifications.

Standard Voltage:
Condition Accel Sensor Out No. 1 Accel Sensor Out No. 2
Accelerator pedal released 0.6 to 1.0 V 1.4 to 1.8 V
Accelerator pedal depressed 2.8 to 3.6 V 3.6 to 4.4 V


HINT:

If the results are not as specified, check the accelerator pedal, wire harness and ECM.