Home › Engine / Hybrid System › N04C-VQ (ENGINE CONTROL) › MANIFOLD ABSOLUTE PRESSURE SENSOR
RM2850E _51 Engine / Hybrid System _073138 N04C-VQ ENGINE CONTROL _0355862 MANIFOLD ABSOLUTE PRESSURE SENSOR G

N04C-VQ ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421E 1.INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR

a.

Turn the ignition switch to ON.


b.

Measure the resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
B104-13 (VC) - B104-14 (E) Ignition switch ON 4.75 to 5.25 V



c.
A257922E01
0.084,0.812 0.388,0.976 0.304,0.164 10 SST 2.515,0.208 2.68,0.372 0.165,0.164 10 *1 1.003,1.49 0.588,0.896 0.588,0.896 0.443,0.896 false 2.234,0.669 2.451,0.291 2.451,0.291 2.514,0.291 false

Using a 3-way connector, connect SST (turbocharger pressure gauge) to the hose leading to the manifold absolute pressure sensor, and then measure the voltage between the terminals.

SST
09992-00242  

Standard Voltage:
Tester Connection Condition Specified Condition
B104-5 (PIM) - B104-14 (E) When negative pressure of 40 kPa {300 mmHg} is applied 0.1 to 0.7 V
Open to atmosphere 0.8 to 1.5 V
When positive pressure of 70 kPa (0.7 kgf/cm2) is applied 1.6 to 2.3 V


Text in Illustration
*1 Manifold Absolute Pressure Sensor

HINT:

The figures above are from data measured at standard atmospheric pressure. Figures may be affected by factors such as altitude and climate. Standard atmospheric pressure is 101 kPa.

This decreases 1 kPa with every 100 m increase in altitude. Atmospheric pressure changes with the weather.