35301A
1.INSTALL FRONT OIL PUMP OIL SEAL
Using SST and a hammer, install a new front oil pump oil seal.
The oil seal end should be flush with the outer edge of the oil pump body.
Coat the oil seal lip with MP grease.
35321
2.INSTALL FRONT OIL PUMP DRIVE GEAR
Coat the front oil pump driven gear and front oil pump drive gear with ATF.
Install the front oil pump driven gear and front oil pump drive gear to the oil pump body.
35308
3.INSTALL FRONT OIL PUMP COVER SUB-ASSEMBLY
Place the oil pump body on the torque converter clutch.
Align the stator shaft with each bolt hole.
Install the front oil pump cover with the 7 bolts.
21 N*m (214 kgf*cm, 16 ft.*lbf)
35495
4.INSTALL CHECK BALL
Install the check ball and compression spring.
Using a SST, shorten compression spring and them install the check valve spring seat.
35617
5.INSTALL CLUTCH DRUM OIL SEAL RING
Coat 2 new oil seal rings with ATF, and install them to the starter shaft.
Do not expand the ring ends excessively.
6.INSTALL OIL PUMP DRIVE GEAR ROTATION