34714
1.INSPECT OVERDRIVE 1 WAY CLUTCH
34601
2.REMOVE OVERDRIVE DIRECT CLUTCH
Remove the overdrive direct clutch drum sub-assembly from the overdrive planetary gear assembly.
Be careful not to damage the overdrive direct clutch drum bush by the overdrive planetary gear assembly.
Remove the 2 thrust bearing races, thrust needle roller bearing from the overdrive planetary gear assembly.
35633D
3.REMOVE OVERDRIVE DIRECT CLUTCH CLUTCH DISC
Using a screwdriver, remove the overdrive clutch flange hole snap ring from the overdrive direct clutch drum sub-assembly.
Remove the overdrive clutch flange, 3 overdrive direct clutch discs, 3 overdrive direct clutch plates from the overdrive direct clutch drum sub-assembly.
35633D
4.INSPECT OVERDRIVE DIRECT CLUTCH CLUTCH DISC
34604
5.REMOVE OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY
Using a SST and press, shorten the overdrive clutch return spring sub-assembly, and then remove the overdrive clutch return spring hole snap ring.
Step the press at the position where the spring sheet face is 1 to 2 mm lower than the snap ring.
Do not expand the snap ring ends excessively.
Remove the overdrive clutch return spring sub-assembly from the overdrive direct clutch drum sub-assembly.
34602
6.REMOVE OVERDRIVE DIRECT CLUTCH PISTON SUB-ASSEMBLY
Install the verdrive direct clutch drum sub-assembly to the oil pump assembly.
Be careful not to damage the oil pump assembly oil seal ring.
Hold the overdrive direct clutch piston sub-assembly, and apply compressed air into the oil hole.
Remove the overdrive direct clutch piston sub-assembly.
Using a screwdriver with its tip wrapped with tape, remove the 2 O-rings from the overdrive direct clutch piston sub-assembly.
34602
7.INSPECT OVERDRIVE DIRECT CLUTCH PISTON SUB-ASSEMBLY
34601
8.INSPECT OVERDRIVE DIRECT CLUTCH DRUM SUB-ASSEMBLY
35712B
9.REMOVE OVERDRIVE PLANETARY RING GEAR FLANGE OIL SEAL RING
Remove the overdrive planetary ring gear flange oil seal ring from the overdrive planetary ring flange.
34732
10.REMOVE OVERDRIVE PLANETARY RING GEAR FLANGE
Using a screwdriver, remove the overdrive planetary ring gear flange hole snap ring.
Remove the overdrive planetary ring gear flange from the overdrive planetary ring gear.
34736
11.REMOVE NO.2 OVERDRIVE PLANETARY GEAR THRUST WASHER
Using a screwdriver, remove the 1 way clutch hole snap ring from the overdrive planetary gear assembly.
Remove the No.2 overdrive planetary gear thrust washer.
Remove the overdrive 1 way clutch, overdrive 1 way clutch outer race from the overdrive planetary gear assembly.
Remove the No.1 overdrive planetary gear thrust washer from the overdrive planetary gear assembly.
34714
12.REMOVE OVERDRIVE 1 WAY CLUTCH
Remove the overdrive 1 way clutch from the overdrive 1 way clutch outer race.
34710
13.INSPECT OVERDRIVE PLANETARY GEAR ASSEMBLY