34714
1.INSTALL OVERDRIVE 1 WAY CLUTCH
Install the overdrive 1 way clutch from the overdrive 1 way clutch outer race.
34736
2.INSTALL OVERDRIVE PLANETARY GEAR THRUST WASHER NO.2
Install the No.1 overdrive planetary gear thrust washer to the overdrive planetary gear assembly.
Install the overdrive 1 way clutch assembly to the overdrive planetary gear assembly.
Install the No.2 overdrive planetary gear thrust washer.
Using a screwdriver, install the 1 way clutch hole snap ring to the overdrive planetary gear assembly.
If there is any scratch or deformation on the snap ring, replace it with new one.
34732
3.INSTALL OVERDRIVE PLANETARY RING GEAR FLANGE
Install the overdrive planetary ring gear flange from the overdrive planetary ring gear.
Using a screwdriver, install the overdrive planetary ring gear flange hole snap ring.
If there is any scratch or deformation on the snap ring, replace it with new one.
35712B
4.INSTALL OVERDRIVE PLANETARY RING GEAR FLANGE OIL SEAL RING
Coat a new overdrive planetary ring gear flange oil seal ring with ATF.
Install the overdrive planetary ring gear flange oil seal ring.
34602
5.INSTALL OVERDRIVE DIRECT CLUTCH PISTON SUB-ASSEMBLY
Coat 2 overdrive direct clutch piston O-rings with ATF.
Install the 2 overdrive direct clutch piston O-rings to the overdrive direct clutch piston sub-assembly.
Install the overdrive direct clutch piston sub-assembly to the overdrive direct clutch drum sub-assembly.
Be careful not to damage the O-ring.
34604
6.INSTALL OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY
Install the overdrive clutch return spring sub-assembly to the overdrive direct clutch drum sub-assembly.
Using a SST and press, shorten the overdrive clutch return spring sub-assembly, and then install the overdrive clutch return spring hole snap ring.
Stop the press at the position where the spring sheet face is 1 to 2 mm lower than the snap ring.
35633D
7.INSTALL OVERDRIVE DIRECT CLUTCH CLUTCH DISC
Coat the 3 overdrive direct clutch discs, 3 overdrive direct clutch plates with ATF.
Install the 3 overdrive direct clutch discs, 3 overdrive direct clutch plates to the overdrive direct clutch drum sub-assembly.
Install the clutch disc and clutch plate, one after the other, show in illustration.
Before assembling new clutch discs, soak them in ATF for more than 2 hours.
Install the overdrive clutch flange to the overdrive direct clutch drum sub-assembly.
Using a screwdriver, install the overdrive clutch flange hole snap ring from the overdrive direct clutch drum sub-assembly.
8.INSPECT PISTON STROKE OF OVERDRIVE DIRECT CLUTCH
34601
9.INSTALL OVERDRIVE DIRECT CLUTCH
Coat a thrust needle roller bearing and 2 thrust bearing races with petroleum jelly.
Install the thrust needle roller bearing and 2 thrust bearing races to the overdrive planetary gear assembly.
| Inside | Outside | |
|---|---|---|
| A (Race) | 29.7 mm (1.097 in.) | 46.15 mm (1.817 in.) |
| B (Bearing) | 28.5 mm (1.122 in.) | 46.15 mm (1.817 in.) |
| C (Race) | 28.5 mm (1.122 in.) | 46.15 mm (1.817 in.) |
Install the overdrive direct clutch drum sub-assembly to the overdrive planetary gear assembly.
Be careful not to damage the overdrive direct clutch drum bush by the overdrive planetary gear assembly.
34714
10.INSTALL OVERDRIVE 1 WAY CLUTCH