35706P
1.REMOVE FRONT PLANETARY SUN GEAR SUB-ASSEMBLY
Using a SST, remove the front planetary sun gear shaft snap ring.
Remove the front planetary sun gear sub-assembly from the center support sub-assembly.
35632C
2.REMOVE BRAKE CLUTCH DISC
Using a screwdriver, remove the No.1 brake flange hole snap ring.
Remove the No.1 brake flange, 5 brake plates, 5 brake clutch discs.
35632C
3.INSPECT BRAKE CLUTCH DISC
4.REMOVE 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY
Using a SST and press, shorten the 2nd brake piston return spring sub-assembly, and then remove the brake piston return spring hole snap ring.
Stop the press at the position where the spring sheet face is 1 to 2 mm lower than the snap ring.
Remove the 2nd brake piston return spring sub-assembly.
35621
5.REMOVE NO.1 BRAKE PISTON
Using a SST, hold the No.1 brake piston, and apply compressed air into the oil hole.
Remove the No.1 brake piston.
Using a screwdriver with its tip wrapped with tape, remove the 2 No.1 brake piston O-rings from the No.1 brake piston.
35709C
6.REMOVE CENTER SUPPORT OIL SEAL RING
Remove the 2 center support oil seal rings from the center support sub-assembly.
Be careful not to damage the center support oil seal ring.
35709B
7.REMOVE CENTER SUPPORT O-RING
Remove the 3 center support O-rings from the center support sub-assembly.
35785
8.REMOVE CENTER SUPPORT RING RETAINER
Remove the 3 center support retainers from the center support sub-assembly.
35709
9.INSPECT CENTER SUPPORT SUB-ASSEMBLY
35706P
10.INSPECT FRONT PLANETARY SUN GEAR SUB-ASSEMBLY