Home › Drivetrain › A444E (AUTOMATIC TRANSMISSION / TRANSAXLE) › FRONT CLUTCH ASSEMBLY › 2017.01–2021.01
RM2850E _52 Drivetrain _073139 A444E AUTOMATIC TRANSMISSION / TRANSAXLE _0355883 FRONT CLUTCH ASSEMBLY A

A444E AUTOMATIC TRANSMISSION / TRANSAXLE  FRONT CLUTCH ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 35712A 1.REMOVE INPUT SHAFT OIL SEAL RING

a.
C175617

Remove the input shaft oil seal ring.


Hide 35654 2.REMOVE REAR CLUTCH HUB

a.
C086990

Install the front clutch assembly to the overdrive support assembly.


b.
C086978

Using a screwdriver, remove the rear clutch hub hole snap ring.


c.
C086979

Remove the rear clutch hub.


Hide 35631E 3.REMOVE FRONT CLUTCH HUB

a.
Q002744

Remove the front clutch hub.


b.
C086981

Remove the thrust needle roller bearing and thrust bearing race.


Hide 35633 4.REMOVE FRONT CLUTCH CLUTCH DISC

a.
C174138

Remove the 7 front clutch clutch discs, 7 front clutch plates, and brake cushion plate.


Hide 35603A 6.REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY

a.
C403429E01
1.406,0.948 1.063,0.5 1.063,0.5 0.813,0.5 false 0.469,0.427 1.031,0.719 0.563,0.292 10 false SST

Using a SST and press, shorten the forward clutch return spring sub-assembly, and ten remove the front clutch piston return spring shaft hole snap ring.

SST
09350-36010  (09350-06010)

NOTICE:
·

Stop the press at the position where the spring sheet face is 1 to 2 mm lower than the snap ring.

·

Do not expand the snap ring ends excessively.




b.
C086986

Remove the forward clutch return spring sub-assembly.


Hide 35602 7.REMOVE FRONT CLUTCH PISTON SUB-ASSEMBLY

a.
C086987

Hold the front clutch piston sub-assembly, and apply compressed air into the oil hole.


b.

Remove the front clutch piston sub-assembly.


c.

Using a screwdriver with its tip wrapped with tape, remove the 2 O-rings from the front clutch piston sub-assembly.


Hide 35602 8.INSPECT FRONT CLUTCH PISTON SUB-ASSEMBLY