Home › Drivetrain › A444E (AUTOMATIC TRANSMISSION / TRANSAXLE) › FRONT CLUTCH ASSEMBLY › 2017.01–2021.01
RM2850E _52 Drivetrain _073139 A444E AUTOMATIC TRANSMISSION / TRANSAXLE _0355883 FRONT CLUTCH ASSEMBLY A

A444E AUTOMATIC TRANSMISSION / TRANSAXLE  FRONT CLUTCH ASSEMBLY  REASSEMBLY  


PROCEDURE

Hide 35602 1.INSTALL FRONT CLUTCH PISTON SUB-ASSEMBLY

a.
C086990

Install the input shaft sub-assembly to the overdrive support assembly.


b.
C087635

Coat 2 new front clutch piston O-rings with ATF.


c.

Install the 2 new front clutch piston O-rings to the front clutch piston sub-assembly.

NOTICE:

Be careful not to damage the O-ring.



d.
C086991

Install the front clutch piston sub-assembly.

NOTICE:

Be careful not to damage the O-ring.



Hide 35603A 2.INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY

a.
Q002853

Install the forward clutch return spring sub-assembly.


b.
C403432E01
1.844,1.083 2,0.49 2,0.49 2.198,0.49 false 1.094,0.74 0.948,0.26 0.948,0.26 0.771,0.26 false 0.438,0.188 1.052,0.552 0.615,0.365 10 false SST 2.271,0.417 2.885,0.781 0.615,0.365 10 false SST

Using a SST and press, shorten the forward clutch return spring sub-assembly, and then install the front clutch piston return spring shaft hole snap ring.

SST
09350-36010  (09350-06010)

CAUTION:

Stop the press at the position where the spring sheet face is 1 to 2 mm lower than the snap ring.



Hide 35633 3.INSTALL FRONT CLUTCH CLUTCH DISC

a.
C086993

Coat a brake cushion plate with ATF.


b.

Install the brake cushion plate.


c.
C175628

Coat the 7 front clutch clutch discs, 7 front clutch plates with ATF.


d.

Install the 7 front clutch clutch discs, 7 front clutch plates.

HINT:

Before assembling new discs, soak them in ATF for at least 2 hours.



Hide 35651B 5.INSTALL REAR CLUTCH DRUM THRUST NEEDLE ROLLER BEARING

a.
C086981

Coat the thrust needle roller bearing, the thrust bearing race with petroleum jelly.


b.

Install the thrust needle roller bearing, the thrust bearing race.

HINT:
Outside Inside
bearing 52.0 mm (2.0472 in.) 32.8 mm (1.2913 in.)
bearing race 52.0 mm (2.0472 in.) 37.0 mm (1.4567 in.)



Hide 35631E 6.INSTALL FRONT CLUTCH HUB

a.
C086980

Install the front clutch hub.


Hide 35654 7.INSTALL REAR CLUTCH HUB

a.
C086979

Install the rear clutch hub.


b.
C086978

Using a screwdriver, install the rear clutch hub hole snap ring.


c.

Remove the front clutch assembly from the overdrive support assembly.


Hide 35712A 8.INSTALL INPUT SHAFT OIL SEAL RING

a.

Install the input shaft oil seal ring to the input shaft sub-assembly.

NOTICE:

Do not expand the oil seal ring excessively.