Home › Drivetrain › A444E (AUTOMATIC TRANSMISSION / TRANSAXLE) › REAR CLUTCH ASSEMBLY › 2017.01–2021.01
RM2850E _52 Drivetrain _073139 A444E AUTOMATIC TRANSMISSION / TRANSAXLE _0355884 REAR CLUTCH ASSEMBLY A

A444E AUTOMATIC TRANSMISSION / TRANSAXLE  REAR CLUTCH ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 35673 1.REMOVE REAR CLUTCH DISC

a.
Q002857

Using a screwdriver, remove the rear clutch flange hole snap ring.


b.
C174139

Remove the 5 rear clutch discs and 5 rear clutch discs.


Hide 35604 3.REMOVE DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY

a.
C403433E01
1.021,0.781 0.792,0.469 0.792,0.469 0.635,0.469 false 2.073,1.854 2.073,1.563 false 0.302,0.396 0.865,0.771 0.563,0.375 10 false SST 1.969,1.865 2.458,2.094 0.49,0.229 10 false SST

Using a SST and press, shorten the direct clutch return spring sub-assembly, and remove the direct clutch piston shaft hole snap ring.

SST
09350-36010  (09350-06010)

NOTICE:
·

Step the press at the position where the spring sheet face is 1 to 2 mm lower than the snap ring.

·

Do not expand the snap ring ends excessively.




b.
Q002862

Remove the direct clutch return spring sub-assembly.


Hide 35606 4.REMOVE REAR CLUTCH PISTON SUB-ASSEMBLY

a.

Install the rear clutch assembly to the center support assembly.


b.
Q002860

While holding center support assembly oil holes, blowing compressed air into the oil holes to remove the rear clutch piston sub-assembly.


c.
C092496

Using a screwdriver with its tip wrapped with tape, remove the 2 rear clutch piston O-rings from the rear clutch piston sub-assembly.


Hide 35606 5.INSPECT REAR CLUTCH PISTON SUB-ASSEMBLY