Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › ENGINE
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355944 ENGINE A

1HZ ENGINE MECHANICAL  ENGINE  PS IDLE-UP SPEED INSPECTION AND ADJUSTMENT  


PROCEDURE

Hide 1.INITIAL CONDITIONS

a.

Engine at normal operating temperature


b.

Air cleaner installed


c.

All accessories switched OFF


d.

All vacuum lines properly connected


e.

Valve clearance set correctly


f.

Injection timing set correctly


g.

Idle speed set correctly


Hide 2.CONNECT TACHOMETER

Hide 3.ADJUST PS IDLE-UP SPEED

a.
A422748

Start the engine.


b.

Turn the steering wheel from the straight-ahead position to full left or full right position.


c.

Check the idle-up speed.

PS idle-up speed:

M/T: 650 +/- 50 rpm

A/T: 710 +/- 50 rpm



d.

Loosen the 2 nuts, and adjust the idle-up setting speed by sliding the idle-up actuator body. Lock the idle-up actuator with the 2 nuts.


e.

Return the steering wheel to the straight-ahead position. Then turn the steering wheel from the straight ahead position to full left or full right position. And recheck the idle-up speed.


f.
A422749

Return the steering wheel to the straight-ahead position, and check that the rod end of the idle-up actuator is not touching the idle-up lever.


g.

Check and adjust the A/C idle-up speed.

Click hereEngine / Hybrid System>1HZ (ENGINE MECHANICAL)>ENGINE>A/C IDLE-UP SPEED INSPECTION AND ADJUSTMENT

NOTICE:

After adjusting the PS idle-up speed, always check the A/C idle-up speed.