Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › CYLINDER BLOCK
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355948 CYLINDER BLOCK A

1HZ ENGINE MECHANICAL  CYLINDER BLOCK  CRANKSHAFT INSPECTION AND REPAIR  


PROCEDURE

Hide 1.INSPECT CRANKSHAFT FOR RUNOUT

a.

Place the crankshaft on V-blocks.


b.
A422448

Using a dial indicator, measure the circle runout at the center journal.

Maximum circle runout:

0.06 mm (0.0024 in.)


If the circle runout is greater than maximum, replace the crankshaft.


Hide 2.INSPECT MAIN JOURNALS AND CRANK PINS

a.
A422449

Using a micrometer, measure the diameter of each main journal and crank pin.

Main journal diameter:
STD:

66.982 - 67.000 mm (2.6371 - 2.6378 in.)

U/S 0.25:

66.745 - 66.755 mm (2.6278 - 2.6281 in.)

U/S 0.50:

66.495 - 66.505 mm (2.6179 - 2.6183 in.)


Crank pin diameter:
STD:

58.982 - 59.000 mm (2.3221 - 2.3228 in.)

U/S 0.25:

58.745 - 58.755 mm (2.3128 - 2.3132 in.)

U/S 0.50:

58.495 - 58.505 mm (2.3029 - 2.3033 in.)


If the diameter is not as specified, check the oil clearance.

Click hereEngine / Hybrid System>1HZ (ENGINE MECHANICAL)>CYLINDER BLOCK>CYLINDER BLOCK DISASSEMBLY


b.

Check each main journal and crank pin for taper andout-of-round as shown.

Maximum taper and out-of-round:

0.02 mm (0.0008 in.)


If the taper or out-of-round is greater than maximum, grind or replace the crankshaft.


Hide 3. IF NECESSARY, GRIND AND HONE MAIN JOURNALS AND/OR CRANK PINS

a.

Grind and hone the main journals and/or crank pins to the finished undersized diameter (See procedure step 2).


b.

Install new main journal and/or crank pin undersized bearings.