1.DRAIN ENGINE COOLANT
2.REMOVE DRIVE BELT, FAN AND WATER PUMP PULLEY
Stretch the belt tight and loosen the four pump pulley set nuts.
Loosen the pivot bolt, lock bolt and adjusting bolt, and remove the drive belt.
Remove the four nuts, fan and fluid coupling (fan spacer) assembly and pulley.
3.REMOVE TIMING BELT AND IDLER PULLEY
13523P
4.REMOVE NO.1 CAMSHAFT TIMING PULLEY
11385
5.REMOVE CAMSHAFT OIL SEAL RETAINER
16100
6.REMOVE WATER PUMP
(1HD-T)
Disconnect the turbo water by-pass hoses.
Remove the three bolts and alternator adjusting bar.
Remove the five bolts, two nuts, No.2 turbo water pipe (1HD-T), water pump and gasket.