Home › Engine / Hybrid System › 1HZ (LUBRICATION) › OIL PUMP
RM2850E _51 Engine / Hybrid System _073154 1HZ LUBRICATION _0355968 OIL PUMP A

1HZ LUBRICATION  OIL PUMP  REMOVAL  


CAUTION / NOTICE / HINT

Click hereEngine / Hybrid System>1HZ (LUBRICATION)>OIL PUMP>COMPONENTS

HINT:

When repairing the oil pump, the oil pan and strainer should be removed and cleaned.


PROCEDURE

Hide 12101 4.REMOVE OIL PAN

a.
A423095

Remove the twenty-three bolts (1PZ) or twenty-seven bolts (1HZ and 1HD-T) and three nuts.


b.
A423096

Insert the blade of SST between the cylinder block and oil pan, cut off applied sealer and remove the oil pan.

NOTICE:
·

Do not use SST for the timing gear case side and rear oil seal retainer.

·

Be careful not to damage the oil pan flange.




Hide 15104 5.REMOVE OIL STRAINER

a.
A423097

Remove the two bolts, two nuts, oil strainer and gasket.


Hide 11301 6.REMOVE OIL PUMP (TIMING GEAR CASE)

a.
A423098

Before removing the two nuts holding the timing gear case to the injection pump, check if the injection pump period lines are aligned.

If not, place new matchmarks for reinstallation.


b.

Remove the two nuts.


c.
A423099

Remove the seven bolts, timing gear case and gasket.


d.
A423100

Using a plastic-faced hammer, lightly tap out the timing gear case.


e.

Remove the gasket.