1.REMOVE DRIVE BELT, FAN AND WATER PUMP PULLEY
2.REMOVE TIMING BELT AND PULLEYS
11385
3.REMOVE CAMSHAFT OIL SEAL RETAINER
4.REMOVE OIL PIPE
Remove the two union bolts and four gaskets.
Remove the bolt and oil pipe.
29300
5.REMOVE VACUUM PUMP
Remove the two nuts and vacuum pump.
Remove the O-ring.
6.REMOVE NO.2 CRANKSHAFT PULLEY (1HZ and 1HD-T)
Remove the six bolts and No.2 crankshaft pulley.
13471
7.REMOVE NO.1 CRANKSHAFT PULLEY
Using SST, remove the pulley bolt and plate.
Using SST, remove the No.1 crankshaft pulley.
Remove the O-ring from the No.1 crankshaft pulley.
11322F
8.REMOVE TIMING GEAR COVER
Remove the fourteen bolts.
Pry out the timing gear cover.
9.CHECK THRUST CLEARANCE OF IDLER GEAR
Using a thickness gauge, measure the thrust clearance.
0.05 - 0.15 mm (0.0020 - 0.059 in.)
0.30 mm (0.0118 in.)
If the thrust clearance is greater than maximum, replace the thrust plate. If necessary, replace the idler gear and/or idler gear shaft.
13522C
10.REMOVE PUMP DRIVE SHAFT GEAR
Using SST, remove the pump drive shaft gear.
13525
11.REMOVE IDLE GEAR
Remove the two bolts, thrust plate, idler gear and idler gearshaft.
13613
12.REMOVE INJECTION PUMP DRIVE GEAR
Using SST, remove the injection pump drive gear set nut.
Remove the O-ring.
Using SST, remove the injection pump drive gear.
Tighten the two bolts of SST more than 8 mm (0.31 in.)
Set the SST so that it is balanced.
13521
13.REMOVE CRANKSHAFT TIMING GEAR
Using SST, remove the crankshaft timing gear.