Home › Engine / Hybrid System › 1HZ STARTING › PRE-HEATING SYSTEM(for Super Glow Type)
RM2850E _51 Engine / Hybrid System _073156 1HZ STARTING _0355974 PRE-HEATING SYSTEM(for Super Glow Type) G

1HZ STARTING  PRE-HEATING SYSTEM(for Super Glow Type)  INSPECTION  


PROCEDURE

Hide 1.INSPECT LIGHTING TIME OF GLOW INDICATOR LIGHT

a.
A423210

Turn the ignition switch ON, and measure the lighting time.

Light lighting time (T1): Refer to the chart graph.


Hide 2.INSPECT AFTER GLOW TIME

a.

Turn the ignition switch ON, and measure the time when batteryvoltage is applied to terminal S-REL of the pre-heating timer.

After glow time (T2)

Refer to the chart graph. (After starting the engine)


Hide 3.INSPECT PRE-HEATING TIMER

a.
A423211

Disconnect the pre-heating timer connector.

LOCATION: Under the instrument panel center.


b.

Inspect the pre-heating timer circuit.

Check the connector on the wire harness side as shown in these chart:

Tester connection Condition Specified value
G-IND - Ground Ignition switch OFF No voltage
Ignition switch ON Battery voltage
IG - Ground Ignition switch OFF No voltage
Ignition switch ON Battery voltage
STA - Ground Ignition switch OFF No voltage
Ignition switch START Battery voltage
S-REL - Ground - Continuity
THW - Ground - Continuity
EG - Ground - Continuity


c.

Reconnect the pre-heating timer connector.