53712C
1.REMOVE FRONT FENDER APRON LH
2.CLEAN SUCTION CONTROL VALVE AND SURROUNDING AREA
Clean the area around the suction control valve assembly as well as any areas that contact other parts using a brush. After that, clean the part using cleaning spray, cloth, etc.
After cleaning with cleaning spray, do not blow air as doing so will cause any dust or sand in the surrounding area to become airborne and adhere to the cleaned area.
Do not allow the fuel temperature sensor connector or fuel pipe to face downward while performing this step.
Check that there is no dirt or foreign matter between the suction control valve assembly and fuel supply pump housing.
04226
3.REMOVE SUCTION CONTROL VALVE ASSEMBLY
Before replacing the suction control valve assembly, be sure to clean the surrounding area.
When replacing the suction control valve assembly, make sure that your hands are clean and do not use gloves, etc.
Be sure to prevent foreign matter or water from entering the lines.
Disconnect the connector from the suction control valve assembly.
Using a 5 mm hexagon wrench, remove the 2 bolts, suction control valve assembly and O-ring from the injection pump.
Do not reuse the suction control valve assembly and O-ring once they have been removed.
Make sure that the O-ring does not remain attached to the injection pump.