1.INSTALL FUEL TANK CUSHION
Install 9 new fuel tank cushions onto the fuel tank as shown in the illustration.
77011
2.INSTALL LOWER FUEL TANK FILLER PIPE SUB-ASSEMBLY
Install a new gasket and the lower fuel tank filler pipe sub-assembly with the 8 screws.
3.INSTALL BREATHER TUBE FUEL HOSE
Install the breather tube fuel hose onto the lower fuel tank filler pipe sub-assembly with the hose clamp.
| *a | Upper |
77213B
4.INSTALL FUEL TANK TO FILLER PIPE HOSE
Install the fuel tank to filler pipe hose onto the lower fuel tank filler pipe sub-assembly with the hose clamp.
| *a | Upper |
77420
5.INSTALL NO. 2 FUEL CUT OFF VALVE ASSEMBLY
Install the No. 2 fuel cut off valve assembly onto the fuel tank.
77380
6.INSTALL FUEL CUT OFF VALVE ASSEMBLY
Install the fuel cut off valve assembly onto the fuel tank.
77026A
7.INSTALL NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Install 2 new gaskets and the No. 1 fuel evaporation tube sub-assembly with the 8 screws and nut.
3.0 N*m (31 kgf*cm, 27 in.*lbf)
77017B
8.INSTALL FUEL TANK VENT TUBE SUB-ASSEMBLY
Install the grommet onto the fuel tank.
Install a new gasket and the fuel tank vent tube sub-assembly with the 6 screws.
83320
9.INSTALL FUEL SENDER GAUGE ASSEMBLY
Install a new gasket and the fuel sender gauge assembly with the 5 screws.
77100
10.INSTALL FUEL TANK ASSEMBLY
Set the fuel tank on a transmission jack.
Raise the jack.Set the fuel tank on a transmission jack.
Connect the 2 fuel tank bands with the 2 bolts.
45 N*m (459 kgf*cm, 33 ft.*lbf)
11.INSTALL BREATHER TUBE FUEL HOSE
Connect the breather tube fuel hose with the hose clamp.
| *a | Upper |
77213B
12.CONNECT FUEL TANK TO FILLER PIPE HOSE
Connect the fuel tank to filler pipe hose with the hose clamp.
| *a | Upper |
13.CONNECT FUEL CHECK VALVE HOSE
Connect the fuel check valve hose with the hose clamp.
14.CONNECT FUEL RETURN HOSE
Connect the fuel return hose with the hose clamp.
15.CONNECT FUEL MAIN HOSE
Connect the fuel main hose with the hose clamp.
58750
16.INSTALL FUEL TANK INSPECTION HOLE COVER ASSEMBLY
Connect the fuel sender gauge assembly connector.
Install the fuel tank inspection hole cover with the 2 screws.
17.ADD FUEL
18.BLEED AIR FROM FUEL SYSTEM
19.INSPECT FOR FUEL LEAK