Home › Engine / Hybrid System › 14B (ENGINE MECHANICAL) › CYLINDER BLOCK › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073170 14B ENGINE MECHANICAL _0356054 CYLINDER BLOCK A

14B ENGINE MECHANICAL  CYLINDER BLOCK  CRANKSHAFT INSPECTION AND REPAIR  


PROCEDURE

Hide 1.INSPECT CRANKSHAFT FOR RUNOUT

a.
A421020

Place the crankshaft on V-blocks.


b.

Using a dial indicator, measure the circle runout at the center journal.

Maximum circle runout:

0.08 mm (0.0031 in.)


If the circle runout is greater than maximum, replace the crankshaft.


Hide 2.INSPECT MAIN JOURNALS AND CRANK PINS

a.
A421021

Using a micrometer, measure the diameter of each main journal and crank pin.

Main journal diameter:
STD No.3 69.950 - 69.970 mm (2.7539 - 2.7547 in.)
Others 69.980 - 70.000 mm (2.7551 - 2.7559 in.)
U/S 0.25 No.3 69.710 - 69.720 mm (2.7445 - 2.7449 in.)
Others 69.740 - 69.750 mm (2.7457 - 2.7461 in.)
U/S 0.50 No.3 69.460 - 69,470 mm (2.7346 - 2.7350 in.)
Others 69.490 - 69.500 mm (2.7358 - 2.7362 in.)
U/S 1.00 No.3 68.960 - 68.970 mm (2.7150 - 2.7153 in.)
Others 68.990 - 69.000 mm (2.7161 - 2.7165 in.)


Crank pin diameter:
STD 60.980 - 61.000 mm (2.4008 - 2.4016 in.)
U/S 0.25 60.740 - 60.750 mm (2.3913 - 2.3917 in.)
U/S 0.50 60.490 - 60.500 mm (2.3815 - 2.3819 in.)
U/S 1.00 59.990 - 60.000 mm (2.3618 - 2.3622 in.)


If the diameter is not as specified, check the oil clearance.

Click hereEngine / Hybrid System>14B (ENGINE MECHANICAL)>CYLINDER BLOCK>CYLINDER BLOCK ASSEMBLY

If necessary, grind or replace the crankshaft.


b.

Check each main journal and crank pin for taper and out-of-round as shown.

Maximum taper and out-of-round:

0.020 mm (0.0008 in.)


If the taper and out-of-round is greater than maximum, replace the crankshaft.


Hide 3. IF NECESSARY, GRIND AND HONE MAIN JOURNALS AND/OR CRANK PINS

a.

Grind and hone the main journals and/or crank pins to the finished undersized diameter.

Install new main journal and/or crankshaft pin undersized bearing.