Home › Engine / Hybrid System › 14B (ENGINE MECHANICAL) › CYLINDER BLOCK › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073170 14B ENGINE MECHANICAL _0356054 CYLINDER BLOCK A

14B ENGINE MECHANICAL  CYLINDER BLOCK  CAMSHAFT BEARINGS AND CAMSHAFT INSPECTION AND REPAIR  


PROCEDURE

Hide 1.INSPECT CAMSHAFT OIL CLEARANCE

a.
A421022

Using a cylinder gauge, measure the inside diameter of the camshaft bearing.

Bearing inside diameter (from front side):
No.1 53.500 - 53.525 mm (2.1063 - 2.1073 in.)
No.2 53.250 - 53.275 mm (2.0965 - 2.0974 in.)
No.3 53.000 - 53.025 mm (2.0866 - 2.0876 in.)
No.4 52.750 - 52.775 mm (2.0768 - 2.0778 in.)
No.5 52.500 - 62.525 mm (2.0669 - 2.0679 in.)



b.

Subtract the journal diameter measurement from the bearing inside diameter measurement.

Click hereEngine / Hybrid System>14B (ENGINE MECHANICAL)>TIMING GEAR>TIMING GEARS AND CAMSHAFT INSPECTION

Standard oil clearance:

0.025 - 0.066 mm (0.0010 - 0.0026 in.)


Maximum oil clearance:

0.10 mm (0.0039 in.)


If the clearance is greater than maximum, replace the camshaft bearings. If necessary, replace the camshaft.


Hide 2.IF NECESSARY, REPLACE CAMSHAFT BEARINGS

a.
A421023

Remove expansion plug

Using SST and a hammer, tap out the expansion plug.

SST
09215-00101  (09215-00130, 09215-00150, 09215-00211)


b.

Remove camshaft bearings

Using SST. remove the camshaft bearings.

SST
09215-00013  (09215-00021, 09215-00471)
09215-00101  (09215-00130, 09215-00141, 09215-00150, 09215-00161)


c.

Install new camshaft bearings

i.
A421025

Install new bearings in their proper location.


ii.
A421026

Align the oil holes of the bearing and cylinder block.


iii.
A421027

Using SST, install the camshaft bearings.

SST
09215-00013  (09215-00021, 09215-00441, 09215-00471)
09215-00101  (09215-00130, 09215-00141, 09215-00150, 09215-00161)



d.

Check camshaft oil clearance (See step (a) above)


e.
A421028

Install expansion plug

i.

Apply liquid sealer to the expansion plug surface of the cylinder block.


ii.

Using SST and a hammer, drive in the expansion plug to a distance of 2 mm (0.08 in.) from the cylinder block edge.

SST
09215-00013  (09215-00471)