1.INITIAL CONDITIONS
Engine at normal operating temperature
Air cleaner installed
All accessories switched OFF
All vacuum lines properly connected
Valve clearance set correctly
Injection timing set correctly
Idle speed set correctly
2.CONNECT TACHOMETER
3.INSPECT AND ADJUST PS IDLE-UP SPEED
Start the engine.
15B-F for BU:
Apply vacuum to idle-up actuator A.
Except 15B-F for BU:
Turn the steering wheel from the straight-ahead position to full left or full right position.
Check the idle-up speed.
3B, 14B (Except Hong Kong) for BB
600 - 700 rpm
14B (Hong Kong) for BB
650 - 750 rpm
15B-F for BU
720 - 770 rpm
15B-FT for BU
700 - 750 rpm
Loosen the 2 nuts, and adjust the idle-up setting speed by sliding the idle-up actuator body. Lock the idle-up actuator with the 2 nuts.
Except 15B-F for BU:
Return the steering wheel to the straight-ahead position. Then turn the steering wheel from the straight-ahead position to full left or full right position, and recheck the idle-up speed.
15B-F for BU:
Release vacuum from idle-up actuator A.
Except 15B-F for BU:
Return the steering wheel to the straight-ahead position, and check that the rod end of the idle-up actuator is not touching the idle-up lever.
Check and adjust the A/C idle-up speed.
Click hereEngine / Hybrid System>14B (ENGINE MECHANICAL)>A/C IDLE-UP SPEED>INSPECTION AND ADJUSTMENT
After adjusting the PS idle-up speed, always check the A/C idle-up speed.