1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51441D
2.REMOVE NO. 1 ENGINE UNDER COVER (for Plastic Type)
51441D
3.REMOVE NO. 1 ENGINE UNDER COVER (for Metal Type)
53712C
4.REMOVE FRONT FENDER APRON LH
32907C
5.REMOVE OIL COOLER TUBE SUB-ASSEMBLY
Remove the 4 bolts and bracket, and separate the oil cooler tube sub-assembly.
28100
6.REMOVE STARTER ASSEMBLY
Pull off the terminal cap and remove the nut, and disconnect the starter wire from terminal 30.
Disconnect the terminal 50 connector from the starter assembly.
| *a | Terminal 50 |
| *b | Terminal 30 |
for Manual Transmission:
Disconnect the 2 wire harness clamps.
Remove the bolt and the wire harness clamp bracket.
for Automatic Transmission:
Disconnect the wire harness clamp.
Remove the nut, bolt, and starter assembly.
|
Bolt |
|
Nut |