Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM2850E _52 Drivetrain _073182 AXLE AND DIFFERENTIAL _0356115 FRONT AXLE HUB A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

Replace the inner and outer races with new ones as a set only if the outer races of the bearings are removed.

Applicable Parts Outer Race Removal and Installation Procedure Reusable/Non-reusable
(Replace the inner and outer races as a set.)
Front axle hub inner bearing Procedure performed Non-reusable
Procedure not performed Reusable
Front axle hub outer bearing Procedure performed Non-reusable
Procedure not performed Reusable


PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.REMOVE BRAKE CALIPER (w/ Disc brake)

a.
C396667

Remove the bolt and disconnect the flexible hose from the steering knuckle.


b.

Remove the 3 bolts and brake caliper.


c.

Support the brake caliper securely.


Hide 43514C 3.REMOVE GREASE CAP

Using a screwdriver, remove the grease cap.

C396668

Hide 4.CHECK AXLE HUB AXIAL PLAY

Using a dial indicator, check the axial play near the center of the axle hub.

C396669

Maximum:

0.05 mm (0.0020 in.)


If the axial play exceeds the maximum, check the hub bearing preload or replace the hub bearings.

Hide 43520A 5.REMOVE AXLE HUB

a.
C396670

Remove the cotter pin and lock cap.


b.

Using socket wrench (35 mm), remove the adjusting nut.


c.
C396671

C396672

Remove the claw washer, outer bearing and axle hub with drum/disc.

NOTICE:

Be careful not to drop the outer bearing.


If the axle hub with drum/disc cannot be removed by hand, use SST to remove it.

SST
09510-36010