Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM2850E _52 Drivetrain _073182 AXLE AND DIFFERENTIAL _0356115 FRONT AXLE HUB A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Replace the inner and outer races with new ones as a set only if the outer races of the bearings are removed.

Applicable Parts Outer Race Removal and Installation Procedure Reusable/Non-reusable
(Replace the inner and outer races as a set.)
Front axle hub inner bearing Procedure performed Non-reusable
Procedure not performed Reusable
Front axle hub outer bearing Procedure performed Non-reusable
Procedure not performed Reusable


PROCEDURE

Hide 43520A 1.INSTALL AXLE HUB

a.

Place the axle hub with drum/disc to the steering knuckle.

NOTICE:

Be careful not to damage the ABS speed sensor rotor (w/ ABS) and oil seal.



b.

Install the outer bearing.


c.

Install the claw washer.


Hide 2.ADJUST PRELOAD

a.
C396680

Using socket wrench (35 mm), install the adjusting nut.

Torque:

108 N*m (1,100 kgf*cm, 80 ft.*lbf)



b.

Turn the axle hub several times to settle down the bearing.


c.

Retighten the adjusting nut.

Torque:

108 N*m (1,100 kgf*cm, 80 ft.*lbf)



d.

Loosen the nut until it can be turn by hand.


e.
C396681

Tighten the adjusting nut by hand and adjust the bearing preload with the spring tension gauge.

Preload (at rotating):

5 - 14 N (0.5 - 1.4 kgf, 1.1 - 3.1 lbf)



f.
C396682

Using a dial indicator, check the axial play near the center of the axle hub.

Maximum:

0.05 mm (0.0020 in.)



g.

Install the lock cap and a new cotter pin.


h.

Install the grease cap.


Hide 3.INSTALL BRAKE CALIPER (w/ Disc brake)

a.
C396683

Install the brake caliper and 3 bolts.

Torque:
A:

245 N*m (2,500 kgf*cm, 181 ft.*lbf)

B:

265 N*m (2,700 kgf*cm, 195 ft.*lbf)



b.

Install the flexible hose to the steering knuckle with the bolt.

Torque:

18 N*m (185 kgf*cm, 13 ft.*lbf)



Hide 4.INSTALL FRONT WHEEL