Replace the inner and outer races with new ones as a set only if the outer races of the bearings are removed.
| Applicable Parts | Outer Race Removal and Installation Procedure | Reusable/Non-reusable
(Replace the inner and outer races as a set.) |
|---|---|---|
| Rear axle hub inner bearing | Procedure performed | Non-reusable |
| Procedure not performed | Reusable | |
| Rear axle hub outer bearing | Procedure performed | Non-reusable |
| Procedure not performed | Reusable |
1.REMOVE REAR WHEEL
42312
2.REMOVE REAR AXLE SHAFT
3.CHECK AXLE HUB AXIAL PLAY
Using a dial indicator, check the axle hub axial play.
0.10 mm (0.0039 in.)
If the axial play exceeds the maximum, check the hub bearing preload or replace the hub bearings.
4.REMOVE BEARING LOCK NUT
Remove the 2 screws and lock nut plate.
Using SST, remove the bearing lock nut.
42430
5.REMOVE AXLE HUB
Using SST, remove the axle hub with drum and outer bearing.
Be careful not to drop the outer bearing.