Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER OIL SEAL
RM2850E _52 Drivetrain _073182 AXLE AND DIFFERENTIAL _0356120 REAR DIFFERENTIAL CARRIER OIL SEAL A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER OIL SEAL  REPLACEMENT  


PROCEDURE

Hide 37100 1.DISCONNECT REAR PROPELLER SHAFT

a.
C397028

Place the matchmarks on the flanges.


b.

Remove the 4 bolts and nuts and disconnect the rear propeller shaft.


Hide 41204 2.REMOVE COMPANION FLANGE

a.
C397029

Using a chisel and hammer, loosen the staked part of nut.


b.
C397030

Using SST, to hold the flange, remove the nut and plate washer.

SST
09330-00021  


c.
C397031

Using SST, remove the companion flange.

SST
09950-40011  


Hide 41201C 3.REMOVE OIL SEAL

C397032

Using SST, remove the oil seal.

SST
09308-10010  

Hide 41201C 4.INSTALL NEW OIL SEAL

a.
C397033

Using SST and a hammer, install a new oil seal.

SST
09309-36010  

Oil seal drive in depth:

1.0 mm (0.039 in.)



b.

Apply MP grease to the oil seal lip.


Hide 41204 5.INSTALL COMPANION FLANGE

a.
C397034

Install the companion flange on the drive pinion.


b.

Place the plate washer on the companion flange.


c.

Apply light coat of gear oil on the threads of a new companion flange nut.


d.

Using SST to hold the flange, torque the nut.

SST
09330-00021  

Torque:

304 N*m (3,100 kgf*cm, 224 ft*lbf)



Hide 6.MEASURE DRIVE PINION PRELOAD

C397035

Using a torque wrench, measure the drive pinion preload.

Bearing preload (at starting):

0.8-1.3 N*m (8-13 kgf*cm, 6.9-11.3 in.*lbf)


If the preload is not within specification, adjust the drive pinion preload.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL CARRIER ASSEMBLY>REASSEMBLY

Hide 41204B 7.STAKE DRIVE PINION NUT

C397036

Hide 37100 8.CONNECT REAR PROPELLER SHAFT

a.
C397037

Align the matchmarks and connect the propeller shaft to the companion flange with the 4 bolts, spring washers and nuts.


b.

Tighten the bolts and nuts.

Torque:

88 N*m (900 kgf*cm, 65 ft*lbf)



Hide 9.INSPECT DIFFERENTIAL OIL LEVEL

Fill with hypoid gear oil if necessary.

C151423

Oil type:

Hypoid gear oil API GL-5


Recommended oil viscosity:

Above -18°C (0°F) SAE 90

Below -18°C (0°F) SAE 80w or 80W-90


Capacity:

3.8 liters (4.0 US qts, 3.3 lmp.qts)