Use the same procedure for RHD and LHD vehicles.
The procedure listed below are for RHD vehicles.
1.INSTALL BODY GREASE
Apply MP grease to the sliding parts of the front door lock assembly RH.
84535C
2.INSTALL DOOR LOCK SWITCH RH (w/ Power Door Lock)
Install the door lock switch RH with the 2 screws.
Connect each terminal to the connector.
69310
3.INSTALL FRONT DOOR LOCK ASSEMBLY RH (w/ Power Door Lock)
Using a T30 "TORX" socket wrench, install the front door lock assembly RH with the 3 "TORX" screws.
5.0 N*m (51 kgf*cm, 44 in.*lbf)
Connect the connector and attach the clamp.
69310
4.INSTALL FRONT DOOR LOCK ASSEMBLY RH (w/o Power Door Lock)
Using a T30 "TORX" socket wrench, install the front door lock assembly RH with the 3 "TORX" screws.
5.0 N*m (51 kgf*cm, 44 in.*lbf)
69210
5.INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY RH
69205
6.INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY RH
67835B
7.INSTALL FRONT DOOR SERVICE HOLE SUB COVER
67601
8.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH
69277B
9.INSTALL FRONT DOOR INSIDE HANDLE BEZEL RH