Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
67863H
1.INSTALL FRONT NO. 2 DOOR WEATHERSTRIP RH
Attach the 10 clips to install the front No. 2 door weatherstrip RH.
67861
2.INSTALL FRONT DOOR WEATHERSTRIP RH
Attach the 40 clips to install the front door weatherstrip RH.
Install the clip.
69310
3.INSTALL FRONT DOOR LOCK ASSEMBLY RH (w/ Power Door Lock)
69310
4.INSTALL FRONT DOOR LOCK ASSEMBLY RH (w/o Power Door Lock)
69205
5.INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY RH
Connect the 2 links.
Install the front door inside handle sub-assembly RH with the 2 screws.
69510
6.INSTALL FRONT DOOR LOCK CYLINDER ASSEMBLY RH
Install the front door lock cylinder assembly RH with the spring.
69210
7.INSTALL FRONT DOOR HANDLE ASSEMBLY OUTSIDE RH
Install the front door handle assembly outside RH as shown in the illustration.
Install the 2 bolts.
5.0 N*m (51 kgf*cm)
Connect the 2 links.
67835B
8.INSTALL FRONT DOOR SERVICE HOLE SUB COVER
Apply new butyl tape to the front door panel, and then install a new front door service hole sub cover as shown in the illustration.
| *a | Reference point |
| *b | Butyl tape |
There should be no wrinkles or folds after attaching the service hole sub cover.
After attaching the service hole sub cover, check the quality of the seal.
67831C
9.INSTALL FRONT DOOR SERVICE HOLE COVER
Apply new butyl tape to the front door panel, and then install a new front door service hole cover as shown in the illustration.
| *a | Reference point |
| *b | Butyl tape |
There should be no wrinkles or folds after attaching the front door service hole cover.
After attaching the front door service hole cover, check the quality of the seal.
74811B
10.INSTALL DOOR PULL HANDLE
Install the door pull handle with the 2 screws.
67601
11.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH
Attach the 15 clips to install the front door trim board sub-assembly RH.
81230
12.INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
69277B
13.INSTALL FRONT DOOR INSIDE HANDLE BEZEL RH
Attach the 2 claws and install the front door inside handle bezel RH.
Install the screw.