Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for RHD vehicles.
1.INSTALL NO. 8 SEAT CUSHION ASSEMBLY
2 or more persons are required for the following procedures in order to prevent damage of the vehicle interior.
Place the No. 8 seat cushion assembly in the cabin.
Set the No. 8 seat cushion assembly in place.
Install the 4 nuts.
39 N*m (400 kgf*cm, 29 ft.*lbf)
| *A | LH Side | *B | RH Side |
79805A
2.INSTALL FRONT FOLD SEAT LEG SUB-ASSEMBLY
Install the front fold seat leg sub-assembly with the 2 bolts.
39 N*m (400 kgf*cm, 29 ft.*lbf)
3.INSTALL NO. 8 SEATBACK ASSEMBLY LH
2 or more persons are required for the following procedures in order to prevent damage of the vehicle interior.
Place the No. 8 seatback assembly LH in the cabin.
Set the No. 8 seat cushion assembly in place.
Install the 2 bolts and 2 nuts.
39 N*m (400 kgf*cm, 29 ft.*lbf)
|
Nut |
|
Bolt |
4.INSTALL NO. 8 SEATBACK ASSEMBLY RH
Use the same procedure described for the LH side.
62609A
5.INSTALL LUGGAGE PARTITION BOARD SUB-ASSEMBLY
Install the luggage partition board sub-assembly with the 4 clips.
79097
6.INSTALL LUGGAGE COMPARTMENT WALL PARTITION SUB-ASSEMBLY
Install the luggage compartment wall partition sub-assembly with 3 new bolts and 5 screws.
10 N*m (102 kgf*cm, 7 ft.*lbf)
|
Screw |
|
Bolt |
7.INSTALL REAR NO. 1 SEAT ASSEMBLY LH
8.INSTALL REAR NO. 1 SEAT ASSEMBLY RH