Wear protective gloves. Sharp areas on the parts may injure your hands.
The procedure listed below is for 1st row to 7th row for long body, and 1st row to 6th row for standard body.
The procedure listed below is a representative example.
Use the same procedure for all rows, unless otherwise specified.
73360B
1.INSTALL REAR SEAT OUTER BELT ASSEMBLY
Check that the rear seat outer belt assembly is not twisted.
Attach the 2 guides.
Connect the rear seat outer belt assembly with the bolt.
42 N*m (428 kgf*cm, 31 ft.*lbf)
w/ Seatback board:
Pass the rear seat outer belt assembly through the No. 1 seatback spring assembly RH as shown in the illustration.
w/ Seatback board:
Pass the rear seat outer belt assembly through the No. 1 seatback cover sub-assembly RH and No. 1 seatback spring assembly RH as shown in the illustration.
Pass the rear seat outer belt assembly through the hole in the No. 1 seatback cover sub-assembly RH as shown in the illustration.
73350C
2.INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY
Use the same procedure as for the rear seat outer belt assembly.
73373D
3.INSTALL REAR SEAT SHOULDER BELT HOLE COVER RH
73375B
4.INSTALL REAR SEAT SHOULDER BELT HOLE COVER LH
Use the same procedure described for the RH side.
73135A
5.INSTALL SHOULDER BELT ANCHOR COVER RH
73136A
6.INSTALL SHOULDER BELT ANCHOR COVER LH
Use the same procedure described for the RH side.
73375M
7.INSTALL REAR SEAT SHOULDER BELT HOLE COVER (w/o Seatback Board)
8.CONNECT REAR SEAT OUTER BELT ASSEMBLY FLOOR ANCHOR
Check that the rear seat outer belt assembly is not twisted.
Install the the floor anchor of the rear seat outer belt assembly with the bolt.
42 N*m (428 kgf*cm, 31 ft.*lbf)
| *a | Location |
The rear seat outer belt assembly must not overlap the location.
9.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY FLOOR ANCHOR
Use the same procedure as for the rear seat outer belt assembly floor anchor.
73373A
10.INSTALL REAR SEAT SHOULDER BELT COVER RH
73375
11.INSTALL REAR SEAT SHOULDER BELT COVER LH
Use the same procedure described for the RH side.
73178A
12.INSTALL SEAT BELT ANCHOR COVER CAP
73179A
13.INSTALL SEAT BELT ANCHOR COVER CAP LH
Use the same procedure as for the seat belt anchor cover cap.
79209
14.INSTALL NO. 2 SEAT BACK BOARD SUB-ASSEMBLY (w/ Seatback Board)
74610A
15.INSTALL ASSIST GRIP SUB-ASSEMBLY (w/ Assist Grip)
74617C
16.INSTALL ASSIST GRIP PLUG (w/ Assist Grip)
71812C
17.INSTALL RECLINING ADJUSTER COVER LH
71811C
18.INSTALL RECLINING ADJUSTER COVER RH
19.INSTALL SUB SEAT ASSEMBLY (w/ Sub Seat)
20.INSTALL REAR NO. 1 SEAT ASSEMBLY RH