Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY(for 2-Passenger Seat with Bench Type Seatback)
RM2850E _58 Vehicle Interior _073190 SEAT BELT _0356185 REAR SEAT OUTER BELT ASSEMBLY(for 2-Passenger Seat with Bench Type Seatback) A

SEAT BELT  REAR SEAT OUTER BELT ASSEMBLY(for 2-Passenger Seat with Bench Type Seatback)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for RHD vehicles.

·

The procedure listed below is for 1st row to 7th row for long body, and 1st row to 6th row for standard body.

·

The procedure listed below is a representative example.

·

Use the same procedure for all rows, unless otherwise specified.



PROCEDURE

Hide 73330G 1.INSTALL REAR SEAT LAP TYPE BELT ASSEMBLY

a.
B472853E01
1.75,0.76 1.208,0.677 1.208,0.677 1.75,0.448 true 2.292,0.771 2.813,0.74 2.813,0.74 2.25,0.448 true 0.99,0.594 1.302,0.792 0.313,0.198 10 false *a 2.896,0.656 3.208,0.854 0.313,0.198 10 false *a

Tighten the bolt to install the rear seat lap type belt assembly.

Torque:

42 N*m (428 kgf*cm, 31 ft.*lbf)


Text in Illustration
*a Location

NOTICE:

The rear seat lap type belt assembly must not overlap the location.



Hide 2.INSTALL NO. 2 SEAT CUSHION COVER WITH PAD

a.

Set the No. 2 seat cushion cover with pad in place.


b.
B472846

Pass the rear seat lap type belt assembly through the hole in the No. 2 seat cushion cover sub-assembly RH.


c.

Attach the 9 hooks to install the No. 2 seat cushion cover with pad to the No. 1 seat leg sub-assembly RH as shown in the illustration.

B472843E01
4.458,0.469 5.115,0.292 true 3.646,0.844 4.448,0.573 true 3.74,3.521 3.74,3.354 false 5.125,3.531 5.125,3.365 false 4.448,3.479 4.448,3.313 false 5.156,0.167 5.469,0.365 0.313,0.198 10 false *a 3.448,0.802 3.76,1 0.313,0.198 10 false *b 5.052,3.542 5.365,3.74 0.313,0.198 10 false *c 3.688,3.542 4,3.74 0.313,0.198 10 false *c 4.365,3.51 4.677,3.708 0.313,0.198 10 false *1

Text in Illustration
*1 No. 1 Seat Leg Sub-assembly RH - -
*a Frame Hole *b Pad Hole
*c Hook - -


d.
B472841

Attach the fastening tape and close the No. 2 seat cushion cover sub-assembly RH.

Text in Illustration
V100145

Fastening Tape


Hide 7.INSTALL SUB SEAT ASSEMBLY (w/ Sub Seat)