Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD
RM2850E _58 Vehicle Interior _073194 SUPPLEMENTAL RESTRAINT SYSTEMS _0356197 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for LHD vehicles.



PROCEDURE

Hide 1.INSTALL HORN BUTTON ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Support the horn button assembly with one hand.


d.
B447298E01
2.073,3 2.292,3 2.292,3 2.49,2.583 true 2.708,2.271 3.021,2.469 0.313,0.198 10 false *b 1.917,2.917 2.229,3.115 0.313,0.198 10 false *a

Connect the airbag connector and lock the lock button.

Text in Illustration
*a Lock Button
*b Push

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



e.

Connect the horn connector to the horn button assembly.


f.

Set the horn button assembly to the steering wheel assembly.


g.

Check that the airbag wire harness and horn wire harness are not pinched.


h.
B468042E01
1.438,1.313 2.406,1.073 2.406,1.073 2.073,1.49 true 1.156,1.615 1.448,1.823 true 2.417,0.948 2.729,1.146 0.313,0.198 10 false *a 1,1.5 1.313,1.698 0.313,0.198 10 false *b

Press the horn button assembly with both hands to attach the 3 pins, to the torsion spring.

HINT:

Attach the 2 upper pins before attaching the lower pin.


Text in Illustration
*a Upper Pin
*b Lower Pin

i.

Pull the horn button assembly towards you and check that it is securely attached.



Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

(Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)