Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM2850E _58 Vehicle Interior _073194 SUPPLEMENTAL RESTRAINT SYSTEMS _0356198 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

for 2 Connectors Type:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 2 Connectors Type)>PRECAUTION

for 3 Connectors Type:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 3 Connectors Type)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT BATTERY NEGATIVE TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45130 4.REMOVE HORN BUTTON ASSEMBLY

Hide 45100 5.REMOVE STEERING WHEEL ASSEMBLY

Hide 45287 6.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 7.REMOVE UPPER STEERING COLUMN COVER

Hide 84306 8.INSPECT SPIRAL CABLE SUB-ASSEMBLY

a.

Check that the front wheels are facing straight ahead.


b.
B464683E01
1.698,0.844 2.135,1.167 0.438,0.323 2.906,2.573 2.906,1.948 2.906,1.948 3.156,1.948 true 2.458,3.156 2.813,3.156 2.813,3.156 2.813,2.646 true 3.177,1.854 3.396,2.052 0.219,0.198 10 false *a 2.292,3.063 2.531,3.26 0.24,0.198 10 false *c 1.729,0.854 1.927,1.01 0.198,0.156 10 true *b

Check that the spiral cable sub-assembly is center position.

OK:

The connector is at the top.

The matchmarks are aligned.

The top of the flat cable U-turn can be checked from the check window.


Text in Illustration
*a Check Window
*b Matchmark
*c Top of Flat Cable U-turn

NOTICE:

If the result is not as specified, it is possible that the spiral cable sub-assembly is broken. Replace the spiral cable sub-assembly with a new one.



Hide 84306 9.REMOVE SPIRAL CABLE SUB-ASSEMBLY

a.
B464677E01
1.458,2.885 0.771,2.427 true 1.521,2.823 1.833,3.021 0.313,0.198 10 false *a

Slide the slider to release the lock, and then disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


Text in Illustration
*a Slider
V100137

Slide in this Direction


b.

Disconnect each connector.


c.
B284474

Detach the 3 claws and remove the spiral cable sub-assembly.