Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column.
for 2 connectors Type:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 2 Connectors Type)>PRECAUTION
for 3 connectors Type:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 3 Connectors Type)>PRECAUTION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
4.REMOVE HEADLIGHT ASSEMBLY LH (for LHD)
for Single Beam Headlight:
Click hereVehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(for Single Beam Headlight)>REMOVAL
for Dual Beam Headlight:
Click hereVehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(for Dual Beam Headlight)>REMOVAL
5.REMOVE HEADLIGHT ASSEMBLY RH (for RHD)
Use the same procedure as for the LH side.
52119A
6.REMOVE FRONT BUMPER COVER
w/o Snorkel Air Cleaner:
Click hereVehicle Interior>EXTERIOR>FRONT BUMPER(w/o Snorkel Air Cleaner)>REMOVAL
w/ Snorkel Air Cleaner:
Click hereVehicle Interior>EXTERIOR>FRONT BUMPER (w/ Snorkel Air Cleaner)>REMOVAL
45130
7.REMOVE HORN BUTTON ASSEMBLY
45100
8.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel assembly set nut.
Place matchmarks on the steering wheel assembly and main shaft assembly.
| *a | Matchmark |
Using SST, remove the steering wheel assembly.
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
| *a | Hold |
| *b | Turn |
45287
9.REMOVE LOWER STEERING COLUMN COVER
w/ Tilt Steering Column:
Remove the 5 screws.
Disengage the 6 claws and remove the lower steering column cover.
w/o Tilt Steering Column:
Remove the 5 screws.
Disengage the 4 claws and remove the lower steering column cover.
45286B
10.REMOVE UPPER STEERING COLUMN COVER
Remove the upper steering column cover.
11.REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY (w/ Airbag System)
84650
12.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
84140
13.REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
45210
14.DISCONNECT STEERING MAIN SHAFT ASSEMBLY
Remove the bolt and slide the steering main shaft assembly upwards.
Do not disconnect the steering main shaft assembly from the power steering gear assembly.
| *a | Matchmark |
Place matchmarks on the steering main shaft assembly and power steering gear sub-assembly to control valve shaft.
Disconnect the steering main shaft assembly from the power steering gear.
58191
15.REMOVE FRONT FLOOR FOOTREST (for RHD)
Remove the 2 screws and front floor footrest.
58651A
16.REMOVE FRONT NO. 1 DOOR MAT PLATE
Detach the 2 screws and 2 clips and slide the front No. 1 door mat plate so that the floor carpet is turned up.
17.REMOVE STEERING COLUMN ASSEMBLY
Disconnect the connector and disengage the 3 clamps.
| *A | w/ Tilt Steering Column | *B | w/o Tilt Steering Column |
Remove the 2 bolts, wire harness clamp bracket and wire harness.
Remove the 4 bolts.
| *A | w/ Tilt Steering Column | *B | w/o Tilt Steering Column |
Remove the 4 bolts and steering column assembly.