Be sure to follow the correct removal and installation procedures of the airbag ECU assembly.
89170A
1.INSPECT AIRBAG ECU ASSEMBLY (for Vehicle not Involved in Collision)
Perform a diagnostic system check.
for 2 Connectors Type:
for 3 Connectors Type:
89170A
2.INSPECT AIRBAG ECU ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
Perform a diagnostic system check.
for 2 Connectors Type:
for 3 Connectors Type:
Visually check for defects with the airbag ECU assembly installed on the vehicle.
The defects are as follows:
Cracks on the airbag ECU assembly housing
Dents on the airbag ECU assembly housing
Chips on the airbag ECU assembly housing
Cracks or other damage to the connector
Peeling of the label
No defects are found.
If any of the defects is found, replace the airbag ECU assembly with a new one.
89170A
3.INSPECT AIRBAG ECU ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)
Replace the airbag ECU assembly (Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG ECU>REMOVAL).
The airbag ECU assembly should be replaced after any of the airbags has deployed, as it has been subjected to an impact.