44310
1.INSTALL VANE PUMP ASSEMBLY
Coat a new O-ring with power steering fluid.
Install the vane pump assembly with the 2 bolts.
20 N*m (204 kgf*cm, 15 ft.*lbf)
Do not jam the O-ring.
44411
2.CONNECT PRESSURE FEED HOSE
Install a new gasket onto the pressure feed hose.
Connect the pressure feed hose to the vane pump assembly with the union bolt.
50 N*m (510 kgf*cm, 37 ft.*lbf)
Make sure that the anti-rotation plate of the pressure feed hose is in contact with the vane pump assembly when connecting the pressure feed hose.
44348A
3.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
Connect the No. 1 oil reservoir to pump hose with the clip.
4.CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
5.ADD POWER STEERING FLUID
6.BLEED POWER STEERING SYSTEM
7.INSPECT POWER STEERING FLUID LEVEL
8.INSPECT FOR POWER STEERING FLUID LEAK
9.INSTALL NO. 1 ENGINE UNDER COVER