Home › Engine / Hybrid System › 1BZ-FPE (ENGINE MECHANICAL) › CYLINDER HEAD › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073200 1BZ-FPE ENGINE MECHANICAL _0356245 CYLINDER HEAD A

1BZ-FPE ENGINE MECHANICAL  CYLINDER HEAD  REMOVAL  


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 2.DISCONNECT PCV HOSES FROM CYLINDER HEAD COVER

Hide 3.DISCONNECT VACUUM HOSE FROM TURBO PRESSURE SENSOR

Hide 4.DISCONNECT VACUUM HOSE FROM DISTRIBUTOR FILTER

Hide 5.DISCONNECT HIGH-TENSION CORDS FROM SPARK PLUGS

Hide 17805 7.REMOVE INTAKE AIR CONNECTOR

a.
A423661

Remove the nut, bolt, intake air connector and gasket.


Hide 26200 8.REMOVE CARBURETOR ASSEMBLY

a.
A423662

Disconnect the auxiliary air valve hose No. 1 from the ISC valve.


b.

Remove the 2 nuts, 2 bolts, carburetor assembly and gasket.


Hide 16206 9.REMOVE WATER BY-PASS PIPE

a.
A423663

Disconnect the 3 water hoses from the water by-passpipe.


b.

Remove the nut, bolt and water by-pass pipe from the intakemanifold.


Hide 17111 10.REMOVE INTAKE MANIFOLD

a.
A423663

Disconnect the water by-pass hose No. 3 and No. 4 from the ISC valve.


b.

Remove the 2 nuts, 7 bolts, intake manifold assembly and gasket from the cylinder head.


Hide 16331 11.REMOVE WATER OUTLET ASSEMBLY

a.

Remove the 2 nuts holding the water outlet housing to the cylinder head.


b.

Disconnect the water bypass hose form the water pump, and remove the water outlet assembly.


Hide 17141 12.REMOVE EXHAUST MANIFOLD

a.
A423665

Remove the 3 nuts, 6 plate washers, heat insulator and 6 spacers.


b.

Remove the 6 bolts, 4 nuts, exhaust manifold, No.2 heat insulator and gasket.


Hide 11201 13.REMOVE CYLINDER HEAD COVER

a.
A423666

Remove the 4 bolts, 2 nuts, 6 cushions, cylinder head cover and gasket.


Hide 13901 14.REMOVE VALVE ROCKER SHAFT ASSEMBLY

a.

Loosen the lock nuts and adjusting screws.


b.
A423667

Uniformly loosen and remove the 10 bolts, in several passes, in the sequence shown.


c.

Remove the rocker shaft assembly.


Hide 15.REMOVE PUSH RODS

a.

Remove the 8 push rods in order, beginning from the No.1 push rod.

HINT:

Arrange the push rods in correct order.



Hide 11101 16.REMOVE CYLINDER HEAD ASSEMBLY

a.
A423668

Uniformly loosen and remove the 18 cylinder head bolts, in several passes, in the sequence shown.

NOTICE:

Head warpage or cracking could result from removing bolts in incorrect order.



b.
A423669

Lift the cylinder head from the dowels on the cylinder block, and place the cylinder head on wooden blocks on a bench.

HINT:

If the cylinder head is difficult to lift off, pry with a screwdriver between the cylinder head and block.


NOTICE:

Be careful not to damage the contact surfaces of the cylinder head and cylinder block.