Home › Engine / Hybrid System › 1BZ-FPE (FUEL) › LPG REGULATOR › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073202 1BZ-FPE FUEL _0356252 LPG REGULATOR G

1BZ-FPE FUEL  LPG REGULATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 23500 1.INSPECT LPG REGULATOR PRIMARY PRESSURE

a.

Disconnect the fuel hose No.3.


b.

Connect a turbo-charger pressure gauge.

SST
09992-00242  (09992-00320, 09992-00340)


c.

Turn the ignition switch ON.


d.
A422011

Inspect the LPG regulator primary pressure.

Standard pressure:

28.5 - 34.3 kPa (0.29 - 0.35 kgf/cm2, 4.1 - 5.0 psi)

The pressure must not be declined lower than the specified range.


NOTICE:

When working on the fuel system, do not smoke or allow open flames near the work area.



Hide 23500 2.ADJUST LPG REGULATOR PRIMARY PRESSURE

a.

Turn the ignition switch ON.


b.
A422012

Adjust the primary pressure with the primary pressure adjusting screw.

Standard pressure:

28.5 - 34.3 kPa (0.29 - 0.35 kgf/cm2, 4.1 - 5.0 psi)


NOTICE:

When working on the fuel system, do not smoke or allow open flames near the work area.



c.

Adjust the air fuel ratio at idle speed (Idle adjusting screw)

Click hereEngine / Hybrid System>1BZ-FPE (ENGINE MECHANICAL)>CO/HC>INSPECTION